ESPOD SIP IP-Phone 3-lines


  1. General Details
    • 8 BLF icons (Busy extensions
      Indication) on LCD
    • Select and display FXO Line status
      via 8 BLF as Key Phone Set (KTS)
    • Message light indication (Ring, DND,
      No Answer call, voice mail)
    • LCD: 2 x 20 digits with 8 icons BLF
    • Remote DTMF or Ring control Relay
      contacts to Open/Close
    • IPV6 and IPv4 Dual Stack
    • 3 Lines Register to three SIP Servers
    • Auto Provision
    • Wall-mount installation without
      additional brackets
  2. Technical Info

    Navigation Keys

    ES380 provides Navigation Key (Up, Down, Left, Right) to Configure/View from LCD
    display along with OK (confirm change) and C (cancel and go back to previous page).

    8 BLF icons work as Key Telephone Set (KTS)

    ES380 can configures FXO Lines to BLF icons and work as KTS (Key Telephone Set).
    Each FXO Line busy status can be seen from BLF icons and can be selected desire
    FXO Line to dial.

    Remote DTMF to control Relay Open/Close

    Built-in Normal Open (NO) and Normal Close (NC) software control Relay, ES380 can work as Door Phone and drive Door Open control circuit by activating NO or NC Relay. Or, install at NOC (Network Operation Center) to control Server RESET or Power ON/OFF remotely. Or, Install at residential house for Home Automation control remotely.

    Incoming Ring signal to Control Relay contacts Open/Close

    In a noisy environment, You may not be able to hear incoming ring from ES-380. It supports software controlled NC and NO Relay to activate external amplifier with desire sound and flash light to indicate there is incoming call at this phone set. Activate Screen and Strobe Light when incoming call arrives.

    Wide range of message light View Angle

    ES-380 provides a Message Light Indication with 360 degree wide range view angle. You may see this light ON in a distance when you have Missed Call, incoming Ring, DND and Voice Mail.

    Desktop view angle and Wall mount

    ES-380 can be installed on Desktop and Wall Mounted without additional brackets. The view angle on Desktop position can be adjusted from 30 to 75 degrees. Pull up handle to adjust desktop view angle. iP380 can install on wall by folding bracket and hang it with two screws.

    Management IP Phone is easier than before

    ES-380 support HTTP provision feature via MAC address. An unique MAC address profile at each ES-380 IP phone was configured before installation. Those MAC addresses profiles were created at HTTP, FTP and TFTP server. It allows system manager to change each ES-380 IP Phone configuration and firmware upgrade remotely.

  3. Specifications
    • Interface:
      • Ethernet port (RJ-45, 10/100Base-T)
        • 1-WAN port connect to Ethernet Switch
        • 1-LAN port connect to Computer
        • PoE (IEEE 802.3af ) at WAN port : iP380A only
      • Earphone/Microphone Jack (3.5mm) for Headset:
        • Normal Open(NO), Normal Close(NC) Relay terminal:
          LAN port free two pairs wire.
      • Handset Jack (RJ-10)
      • DC 12V/1A power input Jack
      • LCD Display:
        • Display Format: 20 Characters x 2 lines, icons x 8 pcs
        • View Size: 99(W) x 24 (H) mm
        • LCD Type: STN
      • LCD Language: English and Portugal.
    • IP Network connection
      • WAN: DHCP, PPPoE and Static IP
      • Dynamic DNS (DDNS)
      • VLAN on both WAN and LAN
      • VID (802.1Q/TAG): 3 to 4094
      • User Priority (802.1P): 0 to 7
      • Voice QoS Support
      • SIP QoS Support
      • DNS Client
      • VPN: VPN and L2TP
      • NTP Time Setting with Daylight Saving time
      • IPv4 (RFC 791), IPV6(RFC 2460)
      • IPv6 Auto Configuration (RFC 4862),
      • Static IPv6 Address, IPv6 in IPv4 Tunnel.
      • LAN: Bridge and Router(DHCP Server)
      • DMZ and MAC Clone Setting
      • MAC Address (IEEE 802.3)
      • TCP/UDP (RFC 793/768)
      • RTP/RTCP (RFC 1889/1890)
      • IPV4 ICMP (RFC 792), IPV6 ICMP(RFC 4443)
      • TFTP Client
      • HTTP/HTTPS Server
      • Support IPV4 only, IPV6 only or dual stack mode
    • SIP Protocol :
      • RFC3261 compliance
      • Support up-to 3 SIP Register Accounts (IPv4 and IPv6 are selectable)
      • Configure SIP port and RTP port
      • SIP UDP Protocol
      • Support SIP compact Form
      • SIP Session Timer (RFC 4028)
      • MD5 Digest Authentication
      • Reliability of provisional responses PRACK (RFC3262)
      • Early/Delay media support
      • Offer/answer (RFC3264)
      • Message Waiting Indication (RFC3842)
      • Event Notification (RFC3265)
      • REFER (RFC3515)
      • Support DNS SRV to locate SIP Server (RFC 3263)
      • Support STUN NAT Traversal
      • Support “rport” parameter (RFC 3581)
      • Configure user agent content
      • Send Flash Event: DTMF, SIP INFO, SIP INFO(digit)
      • Configure Encryption Type and key
    • Audio Codec :
      • G.711 A-law/μ-law, G.723
      • G.729A, G.726 (ADPCM), GSM
      • Silence Suppression
      • VAD/CNG
      • Automatic Gain Control
      • DTMF: In-band, Out of Band, RFC2833, SIP INFO.
      • Adaptive/Configurable Jitter Buffer up to 96 packets
      • Acoustic Echo Cancellation
      • Full-Duplex Speaker Phone
      • Volume Adjustment (Receiver and transmitter)
      • Customized Idle Text
      • Clock, Daylight Saving, Call-timer
      • Call History of Missed, Received and Dialed
      • Dialing Plan
      • Digit Manipulation
      • Selectable Call Progress Tone
      • Support Personal Music Ring
      • Auto Answer Mode
      • Support Auto Priority (Auto Switch) Calling
      • Support Specified Line Calling
    • Call Features :
      • BLF x 8 icons with Name and Number
      • Caller ID display or inhibit
      • Voice Mail with Indication
      • Speed Dialing
      • Phone Book x 140 records
      • Flexible Dial Plan Setting – Drop Prefix and Replace Rule
      • Call Waiting/Switching between Calls
      • Call Forward (Busy, Unconditional, No Answer)
      • Hotline function
      • Alarm Time Setting
      • Auto Answer set up
      • Ring Timeout
      • Do not disturb
      • Call Hold
      • Call Mute
      • Call Transfer
      • Configure Tone: Dial Tone, Ring back Tone, Busy Tone, Congestion
        Tone, Ring Tone and Call Waiting Tone.
      • Music-on-hold support (via IPPBX or local)
      • Conferencing (3-way conference over phone)
      • Call Pickup (configure Code)
      • Call Park/Retrieve (via IPPBX)
      • Voice Broadcasting (via IPPBX)
      • Redialing/pre-dialing
      • Support Peer to Peer Dialing
      • Reject Anonymous call
    • Software control Relay features :
      • Configure to Normal Open(NO) or Normal Close(NC) Relay
      • Activate by NO or NC
      • Remote RFC2833 DTMF activate Relay contacts Open/Close
      • Incoming Ring to activate Relay contacts Open/Close.
      • Relay contact specification: 1A at 250V
      • Multilanguage Web User Interface
      • Administrative Telnet CLI Login
      • 3 Levels of User Access Right with Password protection
      • LCD Administration Login
      • Provides System Status
      • Diagnostics via syslog with different log type
      • LAN port bandwidth limitation
      • Configuration Backup/Restore
      • Reset to Default
      • Auto Provision via TFTP, HTTP and FTP with Schedule
      • Auto update firmware via TFTP, HTTP and FTP with Schedule
      • Firmware upgrade via webpage
      • Disable WAN port management
      • Configure WEB Login port (default is 9999)
      • TR-069 (Option)
    • Environmental :
      • Physical Dimension: 190(W) × 90(D) × 210(H) mm
      • Weight: 1.1kg (One unit with packing)
      • Single pack dimension: 225x195x115 mm
      • Operating Temp. & Humidity
        • Temp.: 0°C~45°C (32°F~113°F)
        • Humidity: 10%~90% relative humidity, non-condensing
      • Power Adaptor:
        • INPUT: AC100V~240V, 50/60Hz
        • OUTPUT: DC 12V, 1.0A
      • Power Consumption of PoE : 5.5 Watts
    • Approvals:
      • CE, FCC, LVD and RoHS
  4. Order Enquiry

    Contact form description text

    • 1 + 41 =
  5. Related Products